Новый аппарат (запуск нового аппарата…) полосит как тетрадь в клетку , то голубые то пурпурные полосы при копировании, сканировании.
The new device (launching a new device …) stripes like a notebook into a cell, then blue or purple stripes when copying, scanning.
инструкция по установке без гарантии installation manual bizhub installation manual bizhub
http://sf.uploads.ru/J3DVn.pdf
Вход в сервисный режим Service mode
1. Нажмите на панели кнопку Menu.
2. На дисплее нажмите Counter.
3. Далее с клавиатурной панели введите «Stop 00 Stop 01»
4. Введите пароль CE (сервис инженера), по умолчанию: 9272927292729272
кнопка Stop — физическая красная кнопкаhttps://www.youtube.com/watch?v=vVxJSVb2oCAhttps://www.youtube.com/watch?v=7TVJR4czQCo
мануал Настройки в сервеснмо режиме13. Date & Time Setting/Time Zone Setting (Service Mode)
(1) Display the Service Mode screen. (For details of how to display the Service Mode screen, see the service manual.)
(2) Display the Date & Time Setting/Time Zone Setting screen. (To display the Date & Time Setting/Time Zone Setting screen, press Stop → 3 on the control panel.)
(3) Do not input date and time but touch “Entry” of the Date & Time Setting.
(4) Input the time zone using up/down keys or direct keys.
(5) Touch “Entry” of the Time Zone Setting.
(6) Touch “Apply.”
(7) Touch “OK.”
(8) Touch “Next.”14. Serial number input Note: Serial number input is, if necessary, needed only for the optional devices installed in “9. Installing other options.”
(1) Touch the item you want to enter and input the serial number.
(2) Touch “END.”
(3) For other devices, enter their serial number in the same way.
(4) Touch “END.” (5) Touch “Next.”15. Unit change Note: This function allows the user to select the type of message that will appear when the replacement time arrives for each of the different units.
(1) Select the appropriate message type for each unit.
(2) Touch “Service.”
16. Performing Non-Image Area Erase Check Note: Perform the below at the site where customer uses the machine.
(1) Select the Non-Image Area Erase Check function as follows: Machine → Non-Image Area Erase Check.
(2) Open fully the reverse automatic document feeder or the original cover if loaded. Note:
• Do NOT place a document on the document glass. • Clean the document glass if dirty.
(3) Press the Start key.
(4) Make sure that “Result” is “OK.” Note: If “Result” is “NG1” or “NG2”, review the place and direction of installation, or take measures to block the light source (by covering it, etc.), then perform installation checking again. (If a fluorescent light or other bright light sources exist right above the machine, the light source can hinder installation checking and cause operation errors in the Non-Image Area Erase Check. For detailed information, see the service manual.)
(5) Touch “OK.17. Configuring other options
(1) If any of the following options are installed, refer to the “Configuration procedures” of the installation manual for each option and configure the option(s).
Reverse Automatic Document Feeder DF-628
